Brewing unit no longer fits Replace drain valve
Posted by: Dschingis May 17, 2020 10:47 pm
Hello, everyone,
I'm desperate. On my brewing unit, I changed the cistern spout. I hope that I have put them together properly. At the same time I had to change my drainage valve and driver and I noticed that the release position of the drive was different, like on the videos...After assembling the brewing unit does not fit on the drive. Could this be due to the position of the drive, or did I assemble the brewing unit incorrectly?
Thank you and best regards
Posted by: Dschingis May 20, 2020 11:21 pm
Machine's running again. With a 9V battery I have brought the drive into the basic position. Now the brewing unit fits.
Bean2cup.org > Melitta > Brewing unit no longer fits Replace drain valve