EA6910 connector symbol appears

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.

what was the problem?

Habs solved got ea 82. problem with the Krups ea 82. problem with switching on, two times cappuccino cleaning automatically and then netzwergstercker symbol.
has it fixed like this :
1. netzwergstercker pull then again after 10s purely .
2.while heating up program and cappuccino button hold.
3.Then I have only had the choice to press cappuccino cleaning while he then let water out I have the steam button frückt.


Now she's walking again

Habs solved got ea 82. problem with the Krups ea 82. problem with switching on, two times cappuccino cleaning automatically and then netzwergstercker symbol.
has it fixed like this :
1. netzwergstercker pull then again after 10s purely .
2.while heating up program and cappuccino button hold.
3.Then I have only had the choice to press cappuccino cleaning while he then let water out I have the steam button frückt.


Now she's walking again

I've had the same problem...and I've made on the heating element are 2 cables (blue) behind gumi to control the plate which was desoldered both

Hello guys also have the problem with pulling the plug... What do you want me to do?

Hello and big praise to this forum.

I also had the plug symbol, because one of the two blue cables had no more connection with the heating element.

Then I soldered both blue cables again and at the first start came "heating process started" and then there was a short circuit with both cables shot off.

I'm imagining that the circuit board also "hissed".

Now the machine is completely dead. So no more reaction when switching on etc..

My question(s)
:- What
exactly
do the blue
connections
do
? -

Can there be a problem if I

have

soldered these "swapped"

? -

On the heating element, it looks as if the two blue cables were previously connected to each other by a small wire - can

that be?

- If the circuit board has one gone, would there have to be some resistor, capacitor or something? So I "see" that?


Thank you for your support!

Apparently the NTC is meant to measure the temperature. It's on the heating element, I've got the wires white.

Hello
, look here in the forum under "Krups no longer starts". Since I have been able to solve the problem!