Siemens EQ 6 Series 300

Hello together
, after I cleaned the powder shaft and also disassembled, cleaned and reassembled the grinder, I put the machine into operation and have to realize that the grinder
does not stop.

It starts immediately when you switch it on and only stops again when you switch it off

.

Do you have any ideas?

I wish you every success.

Sometimes even a few diodes are defective, you have to try it out, I hope you have ordered a few more triacs.

@ MartinDen
Triac I have ordered 5 times, the adjacent diode is at least technically ok. Wait and see when the parts come around the 20th
.

I think it should have blown out because the grinder was completely clogged and therefore

ran

sluggishly

.

Wait and see. I'll keep you going as soon as something happens. If necessary, order the whole board for 150.

Hello everyone
,Today finally came the
spare parts.

Triac soldered in and see there, it works again error free.

What is the triac number that you ordered ?

See Picture,from ST Eectronics,Type 11N65.

Thank u for the Triac number! Ordered it a few days ago. Today replaced the Triac and grinder is functioning again.

I'm very happy about that. In this way you do something for the environment and your wallet stays full.