Hello, I have an AEG Caffe Silenzio CS 5000
. I recently had to replace the thermoblock
in this one. Since then I have the following, strange problem
: If I connect the machine to electricity, turn it on immediately and make a cup of coffee it seems to work without any problems.
But if I leave the machine connected to the power supply, after a few minutes it doesn't react to keystrokes anymore. Also not on the on and off switch. So
I have to disconnect
the machine from the power again.
If I connect the machine directly to the power supply again, I can usually turn it on, but I can't make coffee. This only works again when I leave it without power for a while.
In another forum thread I read that you can measure the resistance of the thermoblock, and it should be around 40 Ohm.
I did that, and with 42 Ohm I think it
is ok. Does
anyone have any idea where I can go to
Or what kind of part could be
responsible for this defect? Greetings