Hello community of knowledge,
Since I am at the end of my Latin I hope to find a solution here.
My problem is this. My ESAM6900 had problems with the damper covers after the last decalcification, was found out quite fast, the steam heating had the known leakage ( hole ). No problem, ordered a new heater, nailed it in and lo and behold... it only works partially.
After pressing the steam button, the device starts to produce it diligently, but after about 6-7 seconds, when the cover is properly inflated, it falls off very quickly, as if there was a blockage, the pump continues to pump, judging by the sound it makes against resistance. At some point the machine stops the process with an error message "air in the system"....
I really don't know anymore...
close
Share this post: