WMF 1000 Coffee too hot

Hello



Hopefully someone here is familiar with the WMF 1000. Since the device is probably built by Schaerer, I am very hopeful.

The good piece is from September 2006 and there is no guarantee anymore.

The following problem occurred.

The machine ran fantastically until about 2 months ago and delivered great coffee!

>After a routine cleaning (normal cleaning of the brewing group and others, of course the machine was not screwed on, only the area of the grinder and brewing group was vacuumed out with the vacuum cleaner) it showed spontaneously that the coffee outlet temperature was unusually high and the coffee tasted burnt. As written, this happened all of a sudden. No changes were made to the programming! I was already trying to lower the brewing temperature. Even a reduction from 92 to 85 degrees brought no success. In the meantime, a crack was found in the upper sieve of the brewing group. After the exchange, however, this did not turn out to be decisive either. The problem persists.

Does anyone know the problem and can help?
I would be very grateful.

Hello

Pity that nobody could help me here so far.
In the meantime the following has happened.
I asked a colleague if he could measure the outlet temperature on his WMF 1000 Pro. A comparison showed the same values for both devices. So that can't be it. The temperature is normal!
However, the coffee still tastes good.... And that without any change! Does anyone else have a hint?

i know your problem had the same thought also my machine is defective but it was only the beans where were roasted too long try it with another pack and you will see that was the mistake