Jura S95 no coffee
Posted by: j.lehnene August 19, 2021 10:56 am
Hello everyone,
with my Jura S95 I no longer come into the programming program.
When pressing a button I always get a portion of steam from the steam pipe.
Even when pressing a large coffee and a double large coffee, a portion of steam is generated.
All the other buttons work, but I don't get any coffee because no water runs when I brew because of a blockage.
Both heaters and also the solenoid valve are clear, pump is pumping.
Water supply and steam supply work.
LG:
Jochen
Posted by: Schlawi August 19, 2021 02:34 pm
Then you have to look for the blockage first. If hot water works, the blockage is probably in the ceramic valve or after.
If you press P also comes steam?
Posted by: j.lehnene August 20, 2021 10:33 am
Hello and first of all a THANK YOU for the quick response.
Have now revised the ceramic valve.
The blockage, however, was in the input of the drainage valve.
Everything runs now, only the error that when pressing all buttons in the service area ( behind the service door) and when pressing the coffee and double coffee button only steam is output. It is not a full portion of steam, but only as long as you press the button.
LG:Jochen
Posted by: Schlawi August 20, 2021 12:04 pm
Sounds like control then. Best to get a used and replace.
If you do not find anything, I also have two S95 here that I want to use as a spare parts donor. Since both heaters are defective or leaking and no desire to repair what else.
Posted by: Guest August 20, 2021 01:31 pm
Thanks for the feedback, I also think it's the controller. Will have a look for a used one. Thanks a lot I will give feedback and or get back to you. PPP
Posted by: j.lehnene October 21, 2021 09:04 am
Hello,
have now installed a used control board.
Machine runs like clockwork again.
Many thanks for the help.
Bean2cup.org > Jura > Jura S95 no coffee