Jura Impressa S9 - Replacing the gear wheel

Hi,

on my Impressa S9 the gear wheel of the drive is broken and has to be replaced.
Is there a faster way to do this than via the front panel and removing the brewing unit? (Seems to me to be the current procedure

)Best regards - stay healthy.

The cogwheel on the motor or the guide that is hooked into the brewing unit?
For the motor it is enough to unscrew the upper part and the right side. Then you should get the screws if I remember correctly. You might have to open the front a little bit to
get
the right side part off
.
For the other one you have to remove the brewing unit.

Thanks for the answer,

it's true. Opening the lid and side panel helps, but the front must be loosened.

Many thanks