QUOTE (Kurpierz611 @ Thursday, July 05, 2018, 1:36 PM) |
Hello ,I have just registered Ma to report my experience with this error! I had the same problem on my Krups9010 that it is always stuck when turning on in the automatic maintenance mode! At the end then always appeared please call Technickhotline. Also water circuit is filled came then every time! After I had built it then about 5 Ma completely Aussereiannder all hoses have cleaned and they have reassembled completely it went all at once again! But only for a short time! Now I have found the error with me where it is! It is the water filter in the water tank! So to speak, the filter cartridge! This pulls somewhere air because when screwing in possibly somewhere what was damaged! After I have unscrewed the filter cartridge and switch on the machine comes no automatic maintenance or the water circuit is no longer filled! I have now ordered a new water tank to see if there is possibly something damaged and it has been all the time! Would be great if someone has the same problem and tests it with the removal of the filter cartridge so that one can really push the water tank! Part numberfor a new water tank is MS-5a10165 I hopeI could help many Lg Patrick |
I just replaced the water filter in the water tank. (Not an original filter).
Then the machine notices that a new water filter has been installed and starts filling the water filter with water. That means it goes out of maintenance mode.
After the water filter is filled with water it jumps into the maintenance mode again and comes out this time without error message.
Now I can pull my latte again.
I also find that a water filter original or through a third party doesn't matter. How will the machine recognize that? Is not a printer where on the printer cartridge or toner a chip is installed.
close
Share this post: