[ENA MICRO 5] Remove front spout

Hello,

When I make a coffee with 2 cups, the right nozzle flows much less than the left nozzle.

Does anyone know how to remove the cover so that the nozzles can be cleaned?

Thanks in advance
Jérémy

I'm talking about this part:



Or if anyone has a photo of the disassembled cover, to see how it holds, I'm also a taker!

You can remove this part manually. But it is also very difficult if it is dirty.
So press in the plastic riffle on the side a little and pull it out at the bottom towards the front.
Then you can remove the plastic part upwards.
Everything else is self-explanatory

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.

Hello and thank you Kaffeechris!
I managed to disassemble the bottom, quite easy when you have the method (without you I never would have found).

However, the top piece does not come off, it is clipped?

And a small picture for those who want to see how it's assembled.
I managed by turning the nozzles to "1 coffee" mode, using a small screwdriver to slightly pry (without forcing) the shiny part.

the photo is really small, I repost, sorry I could not edit the old post.