QUOTE (Guest_Guest @ Saturday, 20 February 2021, 15:42) |
Hello everyone,
I would like to briefly describe my experience with the EQ9 S700 Connect. Error: H1086
Automatic connection via WPS failed several times. (why later more) Manual connection has always worked flawlessly. About info also always seen with which WLAN - network I was connected. Thus was also only the WLAN symbol with the X there. (Means: still no connection with the app available )Challenge for me was always to connect to the app. Any attempt has failed, whether manual connection to the app or immediately with Successful connection to the WLAN - network. Coffee machine EQ9 S700 was also not found several times in the app, although in the menu under Info a connection to my Fritz Box 7590 was always present.
In the app error message: H1086Really
tried a lot:
Guest access as I have assigned a very small as well as weak WPA2 with 8 characters WLAN password especially for this problem - without success. Connected to the WLAN network, deactivated the FritzBox WLAN and switched it on again without success. With other mobile phones or even tablet nothing worked. App uninstalled and reinstalled everything without success.
Until I read it in a side sentence here..... "weak or poor data rate" Ok,
last try, my Fritz repeater is mesh integrated and have now taken this directly into the kitchen behind the fully automatic machine and now tried over my normal WLAN network.
(64 characters with special characters etc. as well as exclusively for this action 2.4Ghz activated at the Fritzbox and 5 Ghz deactivated) Oh yes Fritz Box is just 4 meters away from the kitchen. EQ 9 - reset all network settings and here we go again! So I
pressed the WPS button on the repeater and restarted the automatic connection on the EQ9..... Within 10 seconds I was connected to my network...Wow I thought, that's how I imagine it. Opened the Home Connect App and started connecting to a new device.... I couldn't believe it, within a few seconds I was connected to the app and from now on I can use all the advantages including updates.
So in a nutshell: WPA2 key - length does not matter, 2.4Ghz enabled - 5Ghz disabled and direct WLAN in the kitchen directly behind the EQ9 had. You could of course also take his FritzBox, but was too cumbersome for meMay
help someone who wants to save like me at least 3 hours of time.
Otherwise, I can only report positive about the fully automatic coffee EQ9 S700.
Have fun |
Hello everyone
,I had hoped to have finally found the solution with the post. Unfortunately, it did not bring success with me either.
I just do not get the machine in my WLAN and therefore not in the HomeConnect app.
Repeater is virtually in the coffee machine, 5 ghz disabled.
WPS just doesn't work it doesn't happen and the clock runs down.
Manual connection:
I get to the point exactly every time where I can connect to the Home Connect WLAN, then I go back into the app, the window for own WLAN network appears, but it comes ganricht to enter own data, before that it aborts, error message H1083, connection to home device lost.
Home Connect support says it's my wifi, ok...but what else should I set?
Can anyone support me?
Best regards BB
close
Share this post: