ECAM 350.35.W Water in red drip tray

Hello everyone!
Need times your "brain lard"/experience.... ;o)
With the above machine runs during the first rinsing process after switching on, a large amount of water in the small red drip tray. The goes then sometime about ....
When preparing coffee - a few drops into the large collection cup. Rinse (switch off - water into the red cup)
My question: Where/why does a large amount of water come from? Since should come out normally only a few drops as a quantity.(condensate)

What has already been done:
Brewing group below completely revised
Brewing piston above completely revised
Machine completely open operated - totally dry, no water laterally (runs directly from the condensate tank)

Is there possibly the solenoid valve faulty (water distribution) ???

For now - Thank you!
Andy

Hello, probably the solenoid valve is calcified or damaged.
Which descaler do you use, the best is the one on amidosulfonic acid.

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.

Servus!
Yes I use the. Solenoid valve I also have in focus, because I suspect an incorrect water distribution.

Remove the solenoid valve and install a new one, make sure which one was installed and replace it.
Good luck

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.