after I ordered a new brewing unit, I wanted to clean the area around the drive and the valve times properly. After a few years of use, it looks bad there. So I unscrewed the cover to the valve and could see the drainage valve. My idea was now to unscrew the next screws, thinking that I could expose the complete valve and the drive. Which turned out to be wrong. So I screwed everything back together - or almost. Unfortunately I made the mistake of loosening the three screws above the valve. With one screw I could fix the valve above again. But the two screws above it can't find a thread anymore. I'm afraid something fell off inside. Unfortunately I have zero idea what that could have been, nor can I get to that area to check. Anyone a tip ???
close
Share this post: