Hello everyone, maybe someone can help me because slowly I do not know more.
I am a hobby screwdriver and actually repair everything and now I have a 8150, which leads me to despair.
It started with a stuck in the cleaning program which was quickly done by pressing the steam button.During cleaning, he let the water into the lower drip tray.
Have cleaned the screens of the pistons and the drainage valve cleaned and greased.
After that I rinsed the machine and made coffee.after about 10 cups the pomace container symbol blinked.
The microswitches of the pomace container and cleaning slide work (cable to plug measured and switch as well).
Then I noticed that the pressure cylinder is much too low and has missed the underlying microswitch.
I disassembled the cylinder completely and found nothing except for a slightly rusted spring.
In another forum there is also a thread on the subject
https://komtra.de/forum/index.php/Thread/8704-Krups-EA8108-Kaffesatzbeh%C3%A4lter-leeren-und-CLEAN-blinken/
So I have test glued the missing piece to the nose but still the indicator of the Tresterbehälter still flashes.
Then a direct check of the components was done.
-Pump, grinder and motor, gear unit for the water system work - brewing unit
heats and microswitch were all measured through - all
cables to plug of the power unit measured for continuity - NTC
and thermocouple of brewing unit was removed, which was confirmed with a plug symbol so everything is OK.
Now I have bridged the state of the machine that it should actually start but the pomace container symbol flashes unfortunately still.
Either the machine still has a low water protection or I'm missing something?
Have meanwhile all possible start conditions of the microswitch through and still the icon does not disappear.
A way to the factory settings I have unfortunately not found and a reset option lt.Krups also not.
I think that the machine is no longer to bring to life, yet it worries me not to know what it is.
Maybe someone has an ideaGrussRalle
close
Share this post: