Jura E 80 Fine foam nozzle falls down.

Hello, everybody,

hopefully someone can help me.

On my Jura E 80 the fine foam nozzle/milk dispenser falls down from the Connector System. Normally you can screw on the nozzle in the system, if only lightly. I've already pulled up the metal piece, but since the coffee spout is right next to it, there's only a small margin. Is it possible to unscrew this outlet somehow, so that the distributor can be unscrewed completely ? I
hope I was able to
describe
the problem to some extent
. Thank you in advance

.

MfgWaldemar

I have the same problem and have not yet found a solution to the problem.

GreetingsChristian

Hello, for all who still have no solution for this:

:)You can lever out the connecting part of hard plastic from the rubber part e.g. with scissors. Then you screw it alone on the milk part until it is tight and then put the rubber part back on it.
This loosens in the course of time.

That was exactly the solution for me too, thank you very much! ????

Have grad, thanks to your instructions, brought my Jura back in shot!!! Nothing stands in the way of a cappuccino!!!
Thank you!!!!!

Remove metal part Remove rubber Attach rubber to metal part until it fits with a slight twist and reinsert.