Hello and big praise to this forum.
I also had the plug symbol, because one of the two blue cables had no more connection with the heating element.
Then I soldered both blue cables again and at the first start came "heating process started" and then there was a short circuit with both cables shot off.
I'm imagining that the circuit board also "hissed".
Now the machine is completely dead. So no more reaction when switching on etc..
My question(s)
:- What exactly
do the blue connections
do? -
Can there be a problem if I have
soldered these "swapped"? -
On the heating element, it looks as if the two blue cables were previously connected to each other by a small wire - can that be?
- If the circuit board has one gone, would there have to be some resistor, capacitor or something? So I "see" that?
Thank you for your support!
close
Share this post: