Hello coffee drinkers
,I have ventured to change the seal on the EA 9010. With Krups EA 8200 I already had some experience. So far I have also succeeded. I had before and my take apart many photos made, also from the circuit board.
After reassembly, the machine starts normally with welcome and immediately says goodbye and goes off. Before my repair the machine went, Only it often went into maintenance mode.
I have checked the connections on the circuit board x times.
I can get into technician mode and it works, but understanding it requires some experience and knowledge of the French language.
Does anyone have any advice?
LGGerhard
Lehmann
close
Share this post: