Melitta Caffeo Bistro, Display drip tray

Hello together,

have also a similar problem: drip tray lights up permanently.

I exchanged the microswitch first, because the old one had become totally clogged and was no longer clean... I had to supply the pump with water because it had lost too much water through evaporation.
Now the pump is working again but the lamp is burning permanently again after starting up, whether the drip tray is inside or outside. It only goes off when the powder flap has been opened and broken off... then rinsing goes.
cleaning program doesn't work either because it doesn't detect that the drip tray is outside.
I looked at the capacitors and they looked like new... so not inflated or burst or the same..

I would assume it is somehow due to the sensor itself... does anyone know where it is? I looked near the pomace container, but couldn't find anything...

Greeting Mel

Had a similar problem after replacing the drainage valve. => The power on symbol and drip tray symbol flashed although the drawer was inserted - .
Found error: Contact tongues within the two plugs on the right side of the PCB (one 2-pole, one 4-pole) were either completely broken off or cracked (material defect?), therefore power supply defective
!!Appropriate

replacement was available at Co**ad: Order no.:740621-62


.
machine can now be switched on again without problems, no

more

error messages

.

Hello everyone, I have a similar problem but the exact opposite. I changed the micro switch and now the machine does not recognize when the drip tray was removed.
Also not with the cleaning program which is very stupid.
The capacitors both look ok, maybe I should change them anywayThanks

for







your















help.
































LG Marcel

Hello I again, that the display for the drip tray did not light up had to do with the fact that I could start a cleaning program but after a short time the display teopfschale entlehren then came, which then no longer went away. Left condenser replaced as described before and see the machine works again.
LG Marcel
Melitta Caffeo Bistro (E 960-101)

Hello I again, that the display for the drip tray did not light up had to do with the fact that I could start a cleaning program but after a short time the display teopfschale entlehren then came, which then no longer went away. Left condenser replaced as described before and see the machine works again.
LG Marcel
Melitta Caffeo Bistro (E 960-101)