Advanced search

Caffeo Barista TS smart, water does not reach BE

PurPur   

December 22, 2019 11:25 pm

Unregistered

Hello everyone, I've searched the melitta Fred until 2017 and unfortunately couldn't find anything completely suitable. That's what it's all about:Yesterday the brand new TS smart unpacked, set up, adjusted, filled, coffee selected and...nothing. Beans are dosed, ground, the pump pumps but nothing arrives in the cup. Try again, same result, drip tray out and lo and behold, stands full of clear water and in the pomace container is dry powder. dry.gif
What did I do afterwards: brewing unit out and in, various programs and settings tested - in the end it went like this: steam off, switch on again, open the powder compartment for 5 seconds (googled somewhere) and then, without filling, choose coffee cream and then, hard to believe, the desired
coffee arrived in the cup and then everything went as desired.

So first of all, calm down on my part

(something may have been stuck at times).
Early this morning, happily turned on, cappuccino on tap and... again nothing,
so except milk foam, which was good after all^^^The

procedure described above led to success again, then off and on again, reproducibility

and so on, and again nothing worked.
I hope you could follow my detailed description, I am quite
sure that I will complain about it.

The problem is rather two days before Christmas and I would like to have a working machine to avoid

having to set up the nespresso

again

.
If you could help me to find an ad hoc solution I would be
very grateful, thank you very much in advance, Happy Holidays
Greetings from
wetterau Gregor

Martin (Hobbytechniker)

December 27, 2019 01:13 pm

*

Expert

Group: Mitglieder

Posts: 1378

Member No.: 22501

Joined: November 20, 2013

A classic guarantee case...