Hi,
I got a used FNF2 yesterday, but either it has a defect or I am too stupid to insert the trays below...
After switching on (no matter if Power or OK) I get the error message that I should check the shells and I can't acknowledge it. I have already tried in several ways to insert, remove, restart etc... but I can't get any further.
Does anyone have any idea where the sensors are located that check whether the shells are inserted correctly? I would like to check if everything still works as it should... alternative: Maybe someone has a really simple assembly instruction, if there is a trick with this machine... but even if I try: The three parts (4 with rust) only fit well together in one way and can be pushed into the machine (the front panel sticks out about .0.5 - 1 mm?).
So if anyone has any advice... I'd be very grateful.
close
Share this post: