OK - had the "error code 6" of the topic creator actually ignored, because I thought that he certainly has a model with display (actually, that could have struck me in the picture but^^) ... and now in the dawn light (blind still closed^^) found the ERROR CODE DISPLAY (1-digit LED display under the cup tray - also used to set the water hardness level, etc.). For me, it shows a 9 - now it depends on how the samson01 has read the display - from behind it would also be ne 6^^. In addition, I have only 1x read the code - It hangs (all lights on) but believe than in different situations with me. Had yesterday again the forum something rummaged through and found that it is very often the NTC (thermoswitch) on the heating block (wobbles on the cable plugs to loosening of the sensor) and when I entered today the freshly discovered error code in the search, I also came exactly to this topic. Is probably a component in the cent range, which because of its minimal size also often very tricky to repair. Could possibly also be a solution for so some as defective machines on ebay and co ... if you read through the article descriptions, habens the all at some point abandoned^^
Am times curious as my NTC so "beinander" is had to get rid of first here^^
...from another thread (https://www.kaffeevollautomaten.org/forums/index.php?showtopic=38907) :
"my Krups EA 8000 goes after switching on first time in the error 9, where all four red lamps flash. At some point, so after 20 - 30 times off and on, the machine is then ready to start. But it can be that the brewing process then breaks off again with error 9, so I always start with 1-2 rinses. If that is then through, I can prepare virtually unlimited coffee, because the error no longer occurs. Only after the machine has cooled down again does the procedure start anew" (Hobi)
...and I can also agree with the behavior
close
Share this post: