Impressa E60 End position brewing group

Hello,

I removed the brewing group from an E60 and fitted it with new O-rings. The machine works again without any problems. However, the final position of the brewing group seems to be too low, as I hardly bring the marc container out and in. He's touching the big scraper. Where and how this end position is determined. Exactly 4 turns are free at the upper thread of the brewing group.

For your help best thanks

Gruß
Martin

I could answer you here the same now as in the coffee net, just let me know again, if's that was not

--------------------
Grüße, Manuel

Jura ENA Micro 9 (Küche)
Jura xF50 (Büro)
wechselnde Besetzung in der Werkstatt...
P.S.: Support gibt's im Forum, nicht per PN o.ä.

Probably the screw at the bottom of the drainage valve is missing.

Exactly this was my idea, so far there was no feedback

--------------------
Grüße, Manuel

Jura ENA Micro 9 (Küche)
Jura xF50 (Büro)
wechselnde Besetzung in der Werkstatt...
P.S.: Support gibt's im Forum, nicht per PN o.ä.

Hello,

thanks for the replies, the screw at the drainage valve is however tight. In a comparable Jurassic I noticed that only 3 threads can survive at the top. This will probably also result in a higher end position. Can this be related to the encoder on the Brügruppen motor ?

Gruß
Martin

I'm guessing rather a small assembly error of the brewing unit, did you proceed exactly according to the instructions?

--------------------
Grüße, Manuel

Jura ENA Micro 9 (Küche)
Jura xF50 (Büro)
wechselnde Besetzung in der Werkstatt...
P.S.: Support gibt's im Forum, nicht per PN o.ä.

Hello,

the encoder was unfortunately not there and the brewing group is surely assembled correctly (I disassembled it again). Where does the information come from, how far up the brewing group goes ? If the one more revolution is driven it is enough for the pomace container. I will change the brewing groups of the two machines.

mfg
Martin