Hello, maybe someone can help.
After the message Error 8 came up more often now and the day before yesterday the device didn't "recover" by itself anymore I started to revise it. Unfortunately without success.
Now, I noticed this, when I manually test the expanded group:
The lower piston goes too high and then can't swing out as desired because it gets stuck, or it starts swinging too late so that it is already too high and gets stuck.
If I mechanically support the swinging out a little bit from the outside, it works.
Is it perhaps the piston or the gear wheels defective? Repairable or do I need a new group?
close
Share this post: