Hello,
sorry first a sorry in the round falss I do something wrong am absolutely new here.
Now to my problem:
I have a Siemens EQ5 Macchiato.
Treser is no longer dry but has become increasingly wet.
Now wanted to replace brew group seals (piston seal and the two on the blue inlet nozzle) - I also did - reinstalled - water no longer ran out the front but only below in the brewing tray.
Second (fortunately I have ne second brew group) reingebaut - machine ran normally - water and coffee out the front.
Then the 1st brew group taken - old piston seal reinstalled - the same condition everything ran into the drip tray.
Then the 2 small seals on the blue inlet nozzle - here again the old installed and tried again.
Now the brew group also runs normally again and it comes out the spent grains but also wet again.
When I installed the new seals and the water ran into the drip tray, the spent grains were completely dry - but I think this was due to the fact that the water did not reach there or ????.
My question - what can be the reason =???
Are the seals wrong although bought in the local store ????
Why is the spent grains so wet in the meantime.
Please for many and understandable feedback - thanks already in advance.
greetingsMarkus
close
Share this post: