How to get a leaky transition to BG sa

We have repaired our saeco talea giro _ the support valve with new directions and thus achieved a dry ejection of the used coffee grounds. Unfortunately, the machine loses a lot of hot water when dispensing coffee, which flows out to the left under the machine _ in the machine you can see the leakage of water from the so-called transition to the BG. Unfortunately it is not easy to get there, because the whole electronic part:rolleyes: is mounted above it. Where can you find instructions on how to replace the function valve ? (is next door) !

Google times after "talea service manual"
there is then also everything illustrated explained.

It is best not to touch it, the function valve is certainly not leaking if water is leaking to the left (standing in front of the machine), either the boiler connections are leaking or the HWD valve.... you should at least know what exactly is leaking, and for that you have to open the machine......buy something without knowing what is defective, it can quickly become expensive.

We opened the machine and saw during running operation where the water runs out (to do this you have to remove the machine a bit (so the magnet from the lid etc) but the electronics is located above the leaky transition and we have no instructions on how to dismantle them skillfully and safely \ the flowmeter and the support valve we have already renewed . The company in our proximity takes 140€ basic cost before it is clear whether the machine can be repaired - and the coffee is so tasty - so we are driven to try it ourselves \unfortunately we do not have any instructions

And where does the water run out? A picture wouldn't be bad.

have already described above what is leaking..... at least according to experience, take some real photos otherwise nobody can help you here