Brewing unit no longer fits Replace drain valve

Dschingis

May 17, 2020 10:47 pm

Coffee drinker

Group: Mitglieder

Posts: 19

Member No.: 36038

Joined: November 01, 2019

Hello, everyone,

I'm desperate. On my brewing unit, I changed the cistern spout. I hope that I have put them together properly. At the same time I had to change my drainage valve and driver and I noticed that the release position of the drive was different, like on the videos...After assembling the brewing unit does not fit on the drive. Could this be due to the position of the drive, or did I assemble the brewing unit incorrectly?

Thank you and best regards