EAM3500, no hot water

Schicedreck, me hab´s!!1

>It was the damn MV at the steam generator!

>inlet/outlet reversed.
Thereby the high pressure is not reduced and the drip valve is opened from behind.

Well, that's what I think...

Can anyone say something?

Would I really care now?


Cappu tastes

Thanks and greetings
pit

In the other forum Gregor asked the manufacturer about this.
Citation:
In the wrong direction the closure of the valve is not pressure stable, so that the valve is forced open. The arrow on the valve must therefore point in the direction of the thick silicone tube.


greeting Stefan

--------------------
Esam 6600 PrimaDonna
Ich helfe gerne und freue mich über jede Rückmeldung, was leider nicht immer vorkommt. Fragen werden NUR im Forum beantwortet.

Mal bist du Hund, mal bist du Baum.

QUOTE (jokel @ Wednesday, 04 August 2010, 08:33 h)

QUOTE (pit of DO @ Wednesday, 04 August 2010, 05:44 h) Do I understand that both the valve on the pump and the solenoid valve release the pressure? My current idea is to take everything apart and test for continuity, put it in descaler and reassemble it. You see correctly, but there is also an overpressure hose on the thermoblock, the black one that comes out at the side. Your current idea is correct. But be careful with electrical components such as the thermoblock, there have been people who have inserted the complete TB and later wondered why the FJ falls when they switch on the machine. Do you also know that with DL the upper brewing piston has to be decalcified separately? Greeting Stefan

While it would be nice if you wrote whole words instead of abbreviations, not everyone can do something with the abbreviations:wub: