Good day
I would be happy about your tips and help mega.
Troubleshooting
After starting the machine, the symbol of the rinsing process is displayed and you are asked to press Start.
The water runs through and comes out of the machine warm. Then I am asked again to start a rinse cycle. Unfortunately, the process goes into a continuous loop until the water in the water tank is empty or you pull the plug.
What have I tried now?
->NTC temperature sensor ( you two feet right and left of it are ran and measure themselves with OL " does that make sense ?" )
In one direction 1400OhmIn
the other direction against the infinities
-> temperature sensor or sensor was disconnected from the board and measured in the diode mode with 41 Ohm
-> flowmeter detached " unfortunately not aufgekriegt " flushed and blown through with a pump.
You can hear how the magnet rotates.
Note
In another was recommended to make a rinse with vinegar . Unfortunately, I did not come to that.
Does anyone have a tip for me what to try next?
close
Share this post: