AEG CaFamosa CF400 System Filling Water cover
Posted by: ausie-r-n January 02, 2019 11:39 am
Hello guys,
I'm at the end of my rope with my Latin.
I've been trying to get an AEG CaFamosa CF 400 to work for quite some time now.
I can't get rid of the message System Fill Water Reference.
I have already done the following work but without success:
- Brewing group and drainage valve revised
- all hoses cleaned
- tank sleeve seal and holder replaced because broken
- flowmeter replaced
- pump with diaphragm valve replaced
- outlet valve replaced
- control knob steam cover made passable
- solenoid valve disassembled and cleaned
water flows out of the hot water nozzle and I can play it through until the tank is empty, but the message Fill system with water reference stops.
Can someone else give me a hint why it could be.
>Many thanks in advance.
Greetings
ausie-r-n
Posted by: BlackSheep January 03, 2019 06:37 am
Hello,
the flowmeter is connected correctly?
tubing from tank bottom and top further
to pump?
greeting
BS
Posted by: ausie-r-n January 03, 2019 03:28 pm
Hello people,
Problem is solved !!!!!
After checking all cables from flowmeter to board for continuity, I noticed that there was a cold solder joint on the board at the flowmeter plug.
soldered and see since machine works immediately again.
New Thanks for the answers and advice.
Up to next time thank you for the answers and advice.
Up to next time I checked all cables from flowmeter to board for continuity. 
LG
ausie-r-n
Bean2cup.org > AEG > AEG CaFamosa CF400 System Filling Water cover