Impressa C60

Hello, since several years I have my Impressa C60 and was very satisfied so far.
I also cleaned and decalcified her well when she
asked for
it
.

All of a sudden, she's got a temper. When I want coffee, it takes a very long time until something comes; the first three progress bars on the display already light up. (I never paid much attention to it, but I thought it was different: progress means coffee runs

immediately

)Then the coffee runs, but not only out of the nozzles, but also over the handle with which you adjust the height of the coffee spout

.

Does anyone have any idea what I could do? Thank you for every helpful answer.

The only permanent help is to open and clean the spout. He's getting too close over time.

Thank you. I'll take care of it. On the net I find tutorials for it. Is there any experience with this? In other words, which is the most complete? I have already experienced that important steps were forgotten because they seemed too banal to the author.

It's not really witchcraft. There are enough instructions to open the case. Then the front has to go. There
are two screws at the top
and one at the bottom from the front right and left.

I then

disconnect the three connectors from the

power board

that go to the front.

Hose must still

go to the water outlet in the front.

Remove the cable from the guide, then you can normally place the front on the front side.

Put

a cloth

under it and it won't scratch anything.

Then the little Torx screws out. The part that's screwed tight I'm locked in

. You have to leverage that.

Then put the small magnets on their side and

the metal plates as well.

Then you have

the spout in your hand.
Installation is then just the other way around. Do not forget to insert metal plates. I don't put the magnets in until the screws are in. Otherwise, they'll just get
stuck
on the plates
.
Hope it fits some way. Since the F series is the same, I may
have forgotten something.
I just saw that there is a video on Komtra about the extension of the front.