Hello
,I made a very stupid mistake.
I received a Seaco Royal Professional, which was obviously never decalcified.
Logically, it was completely calcified. Pump, flow heater and support valve were completely tight.
Have now got everything working again and the machine is now already delivering hot water. However, it still says "bleed".
I marked all the connectors when I disassembled it but stupidly didn't mark the flowmeter connector and now I don't know where the connector for it is on the control board.
Have 3 3-pin connectors below where the connector fits. But which one is the right one?
Thanks already for infoGreß
Peter
close
Share this post: