Hello,
have just had the problem with the constant error message "refill beans"
(Of course there are enough in it)
The grinder starts normally, but stops again after about 1 second
When testing the system component for 5 seconds it grinds for 5 seconds,
why I would exclude a mechanical defect, unless there is a sensor
which reports coffee beans empty.
A factory reset did not work, it is the same error with all programs.
Here a selection of the values:
Error Log:
BMU843
M01F07H02
GMOC 920
M05F02H03
Error Memory
BU over: 3
Pump TO: 12
Shutdown: 5
Overtemp: 73
Grindover: 1
[Sensor Test[/u]
Tray in 0
Tank 1
Bu up 0
Bu dw 1
Powder 1
Door 0
Tray Full 0
Comp.Test
Pump: 55-59 ml/s
Grinder 5s: avg --> shows nothing but grinds 5 seconds
VC Step Pso.nothing happens
Auto off: goes
Prod.Data
Main Sw 1.01 29.11.10
Main HW 1.0 02.02.11
Stastistics (here I only state the important one, not every single type of coffee)
1064 cups (since 2011)
Clean: 3
Calc'n' Clean: 2 (all agent from BSH service)
What can that only be? The device has never been disassembled...
close
Share this post: