Hello,
had for a few days always the same, "Fill water circuit". Then came automatic maintenance up to the described code 13, call the hotline.
The nice lady said I should take
the machine off the mains for
an hour and then
let it run without water fillers
, rinse at least 5 times and then that should be it. Didn't work, then I opened
the machine from below
outside the warranty.
Then you can see the flowmeter and a water filter which was totally silted up.
Have blown the flowmeter through, you hear a buzzing noise and then the fine filter in the direction of flow again and again with hot water cleaned and blown through. One must have patience, the mud is in it because only cold water is pulled through the filter. Looks disgusting, but in the end the water
is heated.
I have reassembled everything and then comes again to fill the water circuit, then rinsed about 8maI rinse always call the keyboard, then the machine
ran like new.
Greeting Michael
close
Share this post: