Printed Jura e10

Hello
,after switching on the circle with the arrow
to the left
appears immediately
.

When I then open the hot water cover the water runs until the tank

is empty.

So probably not calcification

,huh? Does

anyone have

any advice?

Clean flowmeter times. Is the water jet strong?
Still, descaling can't hurt if you
have
limy water
.

HelloFlowmeter
I have cleaned, turns absolutely
smoothly.

The beam

is strong. salute

Can you set a little video while you're hot watering?
Is the pump loud or does it sound normal?

Pump makes normal noises, but the water is cold.

Check if the tank valve opens correctly. Seal swollen in tank?
Did you have the flowmeter outside? Hoses back on the right side? Plug contacts ok? Pump too weak. If you pull off the inlet at the pump and put on the tank, will there be enough
water?

If you can exclude lime, the last thing left is the control.

Thanks for your help,I'll try again today.

How can I start the descaling program with the machine switched off?

I solved the problem with the decalcifying.
Now the E10 makes
no more noise.

But the BG is now just driving back and forth and then there's the error where all the

symbols are lit up.

The BG hadn't yet made any plans for any

problems. I've swapped

BGs three times

.

But that had already been suggested before

.

The day before the mistake with the arrow, everything was unpleasant

.

Can that be the home position????????