Advanced search

Caffeo Ci System Start Water comes only droplets

Lord   

September 14, 2021 03:02 pm

Unregistered

Hello
, with my Caffeo Ci machine always stands after switching on only system start and if you activate it comes out only dropwise water

Schlawi

September 14, 2021 06:56 pm

*

Expert

Group: Mitglieder

Posts: 1104

Member No.: 14628

Joined: December 26, 2011

Is the pump quiet? Do you have lime water?
You can put descaler in the water tank. But a good one based on amidosulfonic acid. And then press the Rotary again and again and hope that the blockage is loosened.

Cons

January 18, 2022 10:42 pm

Unregistered

Hello,

with my Caffeo CI I also have the system start problem in continuous loop.

Pump is new

Thermoblock new

Outlet valve new

Nevertheless, the pump does not manage to pump the water through.

My remedy:I take off the hose at the Y valve briefly. Then the pump flushes the thermoblock without problems. After that, everything runs normally again.

Then when I put a filter back in and somehow air gets in, no more water is pumped through. This also happens after the evaporation function. So as soon as air comes in somehow, it's over.

What can be the reason for this?

The pump does not manage to push out the discharge valve.

Schlawi

January 18, 2022 10:46 pm

*

Expert

Group: Mitglieder

Posts: 1104

Member No.: 14628

Joined: December 26, 2011

Can hot water and steam be drawn afterwards?
The venting runs via the ceramic valve. Then the fault must be there or after the ceramic valve.

Cons

January 18, 2022 11:33 pm

Unregistered

I have just noticed that hot water does not work. You can hear water dripping into the bowl.

Schlawi

January 19, 2022 10:43 am

*

Expert

Group: Mitglieder

Posts: 1104

Member No.: 14628

Joined: December 26, 2011

Then you have to see if you have a blockage in the direction of the ceramic valve or from the ceramic valve in the direction of the hot water outlet.
It can also be in the ceramic valve.
If there is still a little water coming, you can also try to descale. But with descaler based on amidosulfonic acid.
Maybe you get the then still free if it is lime.


Cons

January 20, 2022 01:18 pm

Unregistered

Thanks for the tipsProblem
solved.
Machine has already 20000 covers but now runs again.
Venting works.
Have removed the lines after the ceramic valve and tried to blow through with your mouth.
At the transparent went nix through, which led to the outlet. So at the other end of the line removed the outlet and then I could blow through....ergo outlet clogged. Cleaned the spout with brush and no more system start loop.

Great and Thanx







Schlawi

January 20, 2022 04:09 pm

*

Expert

Group: Mitglieder

Posts: 1104

Member No.: 14628

Joined: December 26, 2011

Small mistake, big effect. biggrin.gif