Posted by: Gast_micha April 28, 2020 05:02 pm
Hello, I have an AEG Caffe Silenzio CS 5000
. I recently had to replace the thermoblock
in this one. Since then I have the following, strange problem
: If I connect the machine to electricity, turn it on immediately and make a cup of coffee it seems to work without any problems.
But if I leave the machine connected to the power supply, after a few minutes it doesn't react to keystrokes anymore. Also not on the on and off switch. So
I have to disconnect
the machine from the power again.
If I connect the machine directly to the power supply again, I can usually turn it on, but I can't make coffee. This only works again when I leave it without power for a while.
In another forum thread I read that you can measure the resistance of the thermoblock, and it should be around 40 Ohm.
I did that, and with 42 Ohm I think it
is ok. Does
anyone have any idea where I can go to
troubleshoot this?
Or what kind of part could be
responsible for this defect? Greetings
Micha
Posted by: Gast_micha June 01, 2020 08:50 pm
Hey, here's the O.R. again.
The problem has been self-medicated.
For those of you who can find this mail because you have
a similar problem
: I've plugged
the coffee maker into an on-and-off outlet.
I would turn it on for coffee and then turn it off
again right away.
After about a month I noticed that the machine was working correctly again, and in the meantime I have been using it normally for
some time. GreetingsMicha
Bean2cup.org > AEG > Machine can no longer be operated