Melitta Caffeo CI E 930-103

Hello SCHLAWI, Where are actually my and your last entries to my problem remained? Were they simply deleted ? Why ? Greetings Bernd

https://www.kaffeevollautomaten.org/forums/index.php?showtopic=54226&st=0&#entry128711

Hello Schlawi, thanks for the link.Now again to the 2 pole socket.The one
cable is " brown " and the other cable is " red ". The cables are about 10cm long. The
" red " cable is plugged on plug point 1 of the miccro switch above the drip tray
.
The "brown" cable is on the cable connector that is attached to the left side of the outside of the drive housing.I suspect that I
pulled
the cable off
of the plug point on the circuit board
when installing and removing the
housing when changing the drain valve.There are white plug points on the circuit board on the right side arranged vertically from top to bottom.The last plug point in this row has two pins on which the socket fits
.
I'm not sure if the small socket belongs on this pin.
Maybe you could help me again.I'm sorry about the wrong type.You just get older and older and Alzheimer's greets beautiful sometimes.
Thank you and greetings Bernd

Hello Schlawi, . On the board I find on the plug-in point I suspect the imprint " Mot - BE " and the position of the resistorsR 28 , R29 , R26 , R27 , R 33 installed there Thank you and I hope you can help me with this information in my problem Gruß Bernd

HI
, I have a few of the machines at home. Wanted to open one and look, but have not yet come to it. Unfortunately, I do not know the assignment by heart.

Hello Schlawi, thank you very much for your information. The problem has been solved in the meantime. A colleague of yours has confirmed to me that the plug-in point, which I thought was the correct plug-in point, is labeled on the board with "Mot - BE" and several resistor positions, can be equipped with the clear white socket. I wish you and your family health and a Merry Christmas and a Happy New Year. Greetings Bernd