I have a NEFF C77V60N2 which would need an exchange of the coffee spout (and that after just 2 years and 1170 coffee purchases )
This machine is not identical to the N1 model. In other words: You can't simply pull off the screen, but have to loosen it from above with two screws.
So far so good - unfortunately you still can't get to the coffee spout.
Does anyone have an idea or a service manual? At Neff you can order the E-parts very well (7,50 EUR) - only without service instructions rather difficult to install.
thank you for the answer. But you can't reach it from upstairs. Since there's also an aperture from above. And to dismantle them you have to dismantle half the machine. I will take some pictures tonight and put them in. So you can see what I mean. I think that the coffee spout is mounted on the sled behind the coffee spout. The question is only whether screwed or clipped.
Many greetings
Daniel
Gast_Andrea
May 16, 2019 03:22 pm
Unregistered
Hello! I have exactly the same problem with my NEFF fully automatic coffee maker. How do I get that thing with the coffee outlet down????? Did any of you make it?
Burkhard
July 09, 2019 05:47 pm
Unregistered
I did it ! Left and right of the michschäumer, which was already removed, are laschen. If these are bent inwards, the housing can be removed to the front. Rigging, but I can do it.
Then pull off an akabel shoe and the coffee hose. Then you have the spout in your hand.
Burkhard
July 09, 2019 05:50 pm
Unregistered
The left and right side of the milk frother, which has already been removed, are lugs. If these are bent inwards, the housing can be removed to the front. It's a little rakish, but it works.
Then pull off a cable lug and the coffee hose. Then you have the spout in your hand.
obaechthe
November 29, 2019 01:45 pm
Unregistered
Hi! I am in this regard myself Grad tinkering... What mounts do you mean? I only see two noses left and right in a kind of splint. Unfortunately, pushing these back does not work. And I don't dare do anything else because of the danger of breakage...
Ask for help! LG, obaechthe
Gast_Jonathan
October 11, 2020 01:18 am
Unregistered
Does anyone have photos which demonstrate how to do this?
We recently had to replace the coffee spout (distributor, no. 0107) as well, as the coffee had only been coming out of one nozzle for quite some time. Here is a brief explanation of how to remove the cover and get to the distributor.
1) Once you have removed the cover (no. 0106), the next step is to remove the cover (0102). 2) For this, the two clamps must be pressed inwards (see picture 2). This can be done with pliers, for example. Now the cover can easily be pulled out by hand (see attached picture). 3) Now replace the old distributor with the new one and put the cover back on the clamps (before that, of course, reconnect the hose and the cable) and now press the clamps outwards.
We can definitely say that it was worth it to change the distributor, because the coffee now tastes much better!
Gast_Jean
August 30, 2021 02:58 pm
Unregistered
Hi,
The levering out of the two slides on the right and on the left works to some extent, but I can't get the two black slides back into their guides when I reassemble them.
In this respect the question remains for me: How do I loosen the two screws of component 106 (see PDF) or what must be disassembled to get to the two Schrauvben?
close
Share this post: