Hi all,
i have an EQ.6 plus s 700 since march 2019. in the meantime it was 3x in repair.
Repairs:
3.2019: (warranty service
)Immediately upon delivery the grinder was defective, 1st cup selected and nothing workedperformed
repair:
-grinder12
.2020 (warranty service)
Machine reports only a few cups after descaling that it needs to be descaled again.
Performed repair:
-repair KVA EQ.6-.
Pump-Valve-Drain-Set7
.2021 (Invoice amount 209,90 Euro)
Brewing unit jammed, could not be removed alsoPerformed
repair:
-Repair KVA EQ.6-Brewing unit-Instantaneous water heater driveControl moduk
umprogramiert#ValveFlashen
ModulThe
repairs were annoying, with the machine I am very satisfied in intact condition.
In each case the repairs were also carried out swiftly with success.
Unfortunately, the machine has now developed within a very short time on the stainless steel panels unsightly rust stains, although I have always cleaned the machine only with a damp cloth (water) and then rubbed dry with a tea towel.
When I contacted BSH Hausgeräte Service GmbH about these rust stains, I was told to send the machine back in and the mechanic would check whether the panels would be replaced for a fee or free of charge. In the event that the panels are not replaced free of charge and I do not agree to the change for a fee, I must pay the costs incurred.
(A set of full costs. )
Now my questions:
How do you deal with the rust stains on the stainless steel bezels?
Is there a remedy that you can use without any problems and that really helps without damaging the bezels?
Has anyone already changed the bezels on their own?
Already a "thank you" for all helpful answers.
close
Share this post: