Hello all,
I own a Siemens EQ.6 plus s700, purchased January 2022
.After the request for service/cleaning came, I had performed this, but possibly canceled during the process (am no longer sure).
Since then, the device has been stuck in a loop:
1st device switch on.
2nd message: "Device is being flushed after service abort".
3rd message: "Rinse and fill water tank ->start":
4. After about 10 seconds, the unit turns off and it starts over.
I tried it with full and half full tank, and without and with water filter.
The machine is completely cleaned manually.
Now I unfortunately do not know what to do, is there possibly a reset?
Many thanks for all the answers.
close
Share this post: