Jura S95 no coffee

Hello everyone,
with my Jura S95 I no longer come into the programming program.
When pressing a button I always get a portion of steam from the steam pipe.
Even when pressing a large coffee and a double large coffee, a portion of steam is generated.

All the other buttons work, but I don't get any coffee because no water runs when I brew because of a blockage.
Both heaters and also the solenoid valve are clear, pump is pumping.
Water supply and steam supply work.
LG:
Jochen

Then you have to look for the blockage first. If hot water works, the blockage is probably in the ceramic valve or after.
If you press P also comes steam?

Hello and first of all a THANK YOU for the quick response.

Have now revised the ceramic valve.
The blockage, however, was in the input of the drainage valve.

Everything runs now, only the error that when pressing all buttons in the service area ( behind the service door) and when pressing the coffee and double coffee button only steam is output. It is not a full portion of steam, but only as long as you press the button.
LG:Jochen

Sounds like control then. Best to get a used and replace.

If you do not find anything, I also have two S95 here that I want to use as a spare parts donor. Since both heaters are defective or leaking and no desire to repair what else.

Thanks for the feedback, I also think it's the controller. Will have a look for a used one. Thanks a lot I will give feedback and or get back to you. PPP

Hello,

have now installed a used control board.
Machine runs like clockwork again.

Many thanks for the help.