Jura F50 Change brewing unit

Howdy!

I'm trying to change the breasts.

I've already upgraded the old unit.

There is a hose at the bottom of the brewing unit. I removed the clamp and disconnected the tube. I wanted to attach the hose to the new brewing unit.
But there is missing the part where the hose
is put in?

How do I get this off the old

unit? Many thanksRudi

You mean the angle? You'll have to take it from the old brewing unit too. It is also held with a clamp. Possible that you do not see them because there is powder residue on them.

Thanks.

It was very dirty. Now I've seen the staple. There's a hose on the other side. There is a plastic part on the old brewing unit where the hose is attached to it. I have to remove this and use it on the new brewing unit. How do I solve this? Is there a trick to it.

Thanks

Take the top off completely, clean it and put it back on again.

Thanks. I've done that. The bracket at this angle I get very badly attached.
The clamp won't go all the way in. When I want to insert the brewing unit and push the hose through the housing to the other side, the angle goes
off again
and
again.

Why can't I get the clamp pushed all the way through? Am I just too clumsy

?
Thanks

Did you remove the old seal? Not the one still on the angle.

Thanks, it worked.

Now the next stupid question.

The lower hose of the brewing unit, where do I put it through? It's not that long.

There's only one hole that fits. Comes out the drain valve on the other side of the solenoid coil.