QUOTE (Guest @ Monday, 28 September 2020, 17:22) |
really now connect the 2 blue and good is di ebrauchst not such a bullshit is just money making is only mass at plus is something else but at minus can connect the 2 blue has no effect on electronics |
[B][/B] Here you see again that here also very many hobby electricians add their mustard.
Safety devices should absolutely not be bridged! The consequences are not calculable, in the present case the fully automatic machine is connected via a Schuko plug. Since this can also be plugged in two positions, it cannot be ensured that on the N conductor in the device also the N is present. In the worst case, the phase (L conductor or the live conductor) can also be present on the device N! This means that voltage is present on the heater when it is switched off. Since the flow heater in the device also times defective and a so-called body short circuit can occur (voltage on the housing of the DHE), this can uncontrollably heat up the device although the machine is switched off (the KV is also switched off only single-pole)! Since the DHE is made of aluminum cast, there is in such a manipulated device, the danger of a fire, since the temperature fuse was bridged yes. A Fi which is prescribed for years, but is still not present in every household, should trigger in the aforementioned case!
The vorhandenensein of safety devices has nothing to do with money-making!
close
Share this post: