Saeco Odea Go

With my Saeco Odea Go, the brewing group moves immediately after switching on to a position that makes it impossible to remove the group and the ground coffee falls through into the drip tray. Does anyone know the problem?

Hello,

had the same thing just recently. However, the grinding did not work there or did not try it. The switch in the gearbox was defective.
Look for the test mode for the Odea. drive the BG in the home position, then you can
take
it
out.

then open the gearbox and check if the switch still

shifts.

TEST MODE O'DEA GIRO AND GO

Test mode is normally to press the button with the drop of water and switch on the device until the 4 LEDs on the left side are moving in a circle.

Then set the water quantity setting wheel to the middle and press the water button until the descaling symbol flashes. The gear of the brewing unit should be set back to its basic position.

Hope I can help with that.

LG Patrick