Mechanics blocked
Posted by: rdlachmann@gmx.de February 12, 2013 12:19 am
Hello, maybe somebody can help me.... Yesterday, after I had turned on the device and pressed produce a cup, the device started up briefly and then stopped blocked. I opened the machine today and noticed that the stamp used to press in the coffee powder does not completely shut down. After a stroke of about 2 cm, it stops at some hard point or is blocked. I can't figure out what could block this stamp on the stroke path. Maybe an expansion drawing could shed some light. Or does anyone know this error?
Greuss Rolf
Posted by: Gast_CorlitoCaffe July 16, 2013 06:05 pm
Hello,
it may be that dirt has settled in the gear unit. But I would be careful - because the whole setup is really demanding for a layman unlike VA from Delonghi, Saeco and Co. Alternatively I could offer you a cheap repair here in Nuremberg as a Quickmill sales partner. What kind of model is it (for exploded view) or remote support?
MFG
Angelo
Bean2cup.org > Quickmill > Mechanics blocked