EQ 6 brew group drive defective

Hello forum communityI
own a Siemens EQ 6 series 300 where probably the drive of the brew group is defective. It does not manage to press the brew group once when turning on the machine. Three attempts and really agonizing noise and then it says ,,please restart device,,. If I'm lucky he manages it after several restarts. Brew group I have freshly greased. With another brew group the same.
Now I wanted to change the drive but how do I get it out of the housing after unscrewing the 3 Torx screws?
Would be great if you can help me there. Have already googled but found nothing in the direction

Hello, you need to remove the side panels, they are clipped. Instructions for disassembly can be found on the I-Net.
MfG Chris

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.

I have dismantled the side panels. But I can not get the drive out of the underlying plastic frame which holds the side parts.

Hello you need to separate the halves of the housing. Especially since the Durchlauerhitzer must be removed. With a little skill only a few centimeters.
The torx screws are hidden, The bottom plate must also be removed.
Good luck and peace.
MfG Chris

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.

Hello caffeechrisHave
replaced the brew group drive but that was not it. I have to restart it at least 3x then it is ready for use. Before that always comes the message,, restart device,, or ,,please let cool down,,. The brewing unit always tries to shut down when starting but then breaks off. Everything is greased and smooth running.

Hello, it could be that the thermosensor that is mounted on the flow heater below is defective, this should have at room temperature min 120K+- 5 ohm.
Hope you have yourself or someone with multimeter.

MfG Chris

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.

HelloHave
today loosened the cables and removed the circuit board. Part of the connections was oxidized and a resistor on the board was smoked off. Cleaned the contacts and soldered a new resistor. The problem remained. Will probably disassemble the machine and sell it in parts.

Hello Noppi, I do not know any advice now.
However then something new comes into the house.

MfG Chris

--------------------
Alles ist Wiederverwertbar, sogar diese Buchstaben.
Keine Anfragen oder Hilfe, über E-Mail.