QUOTE (rudi-03 @ Wednesday, March 11, 2015, 9:54 PM) |
Have you put your hand in it? You should hear a slight click when you press it. You can also test the whole thing in the switched on state, without brew group. |
Hello...I had the same problem and was very grateful for all the advice and tips here on the forum.
Maybe my experience or the fault on my machine will help others here.
With me, the said microswitch was no longer properly fixed and could be pressed backwards when actuating, not much but noticeably, so that the switch contact could no longer be switched on, but the whole microswitch pressed towards the rear wall.
After I opened the device, I could see that one of the two mounting pins was broken off.
Not professional, but easiest solution, I have the switch with superglue stuck and everything reassembled....und behold, the machine works properly again.
close
Share this post: