Hello people!
I hope someone will help me with a repair of an EQ.5 The following history can help.
>The machine came up with the problem that the FI flies.
The reason was that the heating was leaking.
I replaced it with a new one.
I also immediately installed a new brewing unit.
The machine is now tight.
And now the problem:
Simultaneously when switching on the machine, the BG went into brewing position and doesn't want to leave it any more, no matter what I do.
But strangely enough, no error is displayed.
If I now want to make a cup of coffee, the pump starts immediately (the grinder doesn't start) and the cup is filled with hot water - done.
The machine does not move with the BG into the neutral position, always remains in the brewing position.
Even if I switch off the machine, this does not change, but a normal rinsing process takes place and then the machine is off.
When I switch it on again, the rinsing program comes first normally and then the machine is ready.
A reset to the factory settings also did not help.
I have already tried the test mode (if it really is).
Should the brewing group be tested with "BU UP or BU DW during this test? Nothing moves at all.
Who has a tip where to look for the error?
Thanks in advance for help.
lG
Alois
close
Share this post: