Miele CVA 2660 leaking

Hello,

my Miele CVA 2660 Nespresso is leaking. The tank itself is you when I take it out. But if I plug it into the device, the water immediately runs down the plug connection between tank and housing into the drain pan.

Can anyone help me? Is there a seal in the black plastic plug in the device where the tank is inserted? Because I don't. Maybe this one somehow fell out. Alternatively a solution?

Maybe someone can have a look at it.

Many thanks

but the seal is there only is the finished, there must be a new her (costs about 4€) !

that is the seal for the water tank the same I had also.
you can reorder the seal at the miele dealer and with a little bit of skill exchange it yourself.

once you have the stainless steel case around it, take it off first.
open the door and in the inside right and left of the device there are 4 inbus screws, which turn out until the device is loosely in the box.

>after disassembly we look at the backside there are two hoses which go to the connection for the water tank, you can remove them without thinking but remember which one was where on it.

the backside looks like this shop euras

now it will be a bit difficult because the whole thing now consists of two parts and is secured with three noses. you have to try from behind with a small screwdriver (watchmaker's tool) to lift what is hacked over the noses and pull it from inside. best with one hand into the device where the water tank is plugged to hold and a little pull carefully the whole three times i have needed about an hour because i did not know how to get out of each other.

in the inside page it looks ca so (i am not picasso)

if it now has seal from each other swap and reassemble in reverse order

Hello
Having the same problem with the water tank. Can anyone give me the order number for the gasket?
Use the gasket on the small black part where the water tank is pushed in.

Thank you in advance
Michael

Hello,

These are the parts I ordered from Miele.
I destroyed and reordered the valve body and cap during removal.

Valve body EAN 4002515089712
Sieve EAN 4002513549720
Safety ring EAN 4002513549713
Seal EAN 4002515192306
Cap EAN 4002513549874

Costs were about 28€

Ordered from Miele Customer Service, who were very competent and helpful.

A great guide, thanks to the author.

When the mentioned spare parts are complete, you can make your life a little easier by simply breaking away the 3 clamping straps on the inside when removing the old part. As described above, I lifted the tabs a little from the outside through the back wall of the device with a very small slotted screwdriver and then broke off the tabs from the inside with a second, short screwdriver.