Hello together,
had an Intelia here and would like to briefly describe how to open it.
First you unscrew the bean container. Then the complete cover can be removed at the top, it is slightly pushed into the control panel at the front.
Then remove all the screws of the sides and the rear panel at the top.
Next remove the left side cover, but be careful, it is snapped in at the front and at the rear with lugs and screwed at the bottom from the front.
Then the rear panel can be completely removed with the door after removing the lower screws (bottom left and bottom right behind the door).
To remove the control panel, loosen the hot water valve and unscrew the 4 screws on the side, lever the control panel forward with a screwdriver. Caution behind a nose of the control panel the upper magnet for the door is located in a slit in the right side part, which is towards you.
After removing the control panel, the complete circuit board can be unscrewed, as well as the outlet, which is laterally locked
After removing 2 screws (seen from the distant outlet) in the bottom of the housing, the panel can be removed underneath the outlet. the cover is locked again with 2 tabs in the case bottom, push the tabs upwards through 2 rectangular holes in the case bottom and carefully lever them out to the front with a screwdriver.
This cover must be removed to remove the gear cover.
To remove the gear cover the support must also be removed. To do this, unscrew the 2 screws and pull the support downwards.
After loosening the screws, you can simply remove the gearbox cover straight.
I can't guarantee for the correctness of the manual, because it can vary from model to model.
I don't have the machine anymore, otherwise I could have added pictures to this manual.
Greetings Alfons
--------------------
Schrauben kann jeder, aber mach nichts kaputt.
close
Share this post: